• Hello Guest, welcome to the initial stages of our new platform!
    You can find some additional information about where we are in the process of migrating the board and setting up our new software here

    Thank you for being a part of our community!

The 242 Hotness of Doom

it sure is a nice kit! what did you machine the ears out to to accept the bearing? i asked ben twice and hes being really secretive about it and dancing around the question...
 
Such a sexy exhaust! especially when it goes past meaty tires, and some super clean nickle plated triangle trailing arms.
20130511_200416_zpsf0a21e03.jpg


I'm a little stressed out trying to get this done for RSiPD, but this is encouraging.
20130511_200513_zps53f47588.jpg
 
We'll be in early on Fri if you need help

Good looking out, but I'll be on a plane headed to Seattle Friday morning. I land at 10:30am i hope to be on the road to RSI by 1 with the rest of the caravan.
 
Oh, yeah. I should clarify i meant there was a mess from bleeding the brakes before I took the car on a smokey, sideways test drive. So, I threw down a towel to clean up a little.
 
Back
Top