maxitoman007
Member
- Joined
- Feb 15, 2017
- Location
- Calgary, Alberta, Canada
I am currently performing a CD009 swap into my 87 Volvo 740. I am using yoshifab's stage 3 clutch, pressure plate, and flywheel package. I'm also using their upgraded throwout bearing.
I have yet to bolt up the M46 bell housing to the CD009 as I would first like to make sure I get throwout bearing/pivot ball/slave spacing all figured out by bolting the bellhousing to the engine.
I am currently using the more "pushed out" position on the yoshifab bearing but have yet to space out the pivot ball.
Is there some kind of procedure I could follow for this without just installing the whole swap and testing?
I have bolted up the bell housing to look at the fork angle (I've read perpendicular to the input shaft and even a little more angled towards the slave is optimal?) I do not however want to depress the clutch because nothing is holding the clutch disc in alignment beside the force of the pressure plate. This means the clutch disc would just fall if the clutch disengaged.
Is there some way I can test the clutch disengagement point without installing the full trans?
Thanks in advance.
I have yet to bolt up the M46 bell housing to the CD009 as I would first like to make sure I get throwout bearing/pivot ball/slave spacing all figured out by bolting the bellhousing to the engine.
I am currently using the more "pushed out" position on the yoshifab bearing but have yet to space out the pivot ball.
Is there some kind of procedure I could follow for this without just installing the whole swap and testing?
I have bolted up the bell housing to look at the fork angle (I've read perpendicular to the input shaft and even a little more angled towards the slave is optimal?) I do not however want to depress the clutch because nothing is holding the clutch disc in alignment beside the force of the pressure plate. This means the clutch disc would just fall if the clutch disengaged.
Is there some way I can test the clutch disengagement point without installing the full trans?
Thanks in advance.